Back to Blog
How-to Guides 2026-11-02 Surebeauty Official Site 8 views

How to Use the FaceEvo 3 Ultrasound Facial Machine Safely

How to Use the FaceEvo 3 Ultrasound Facial Machine Safely

A safe, step-by-step routine for the FaceEvo 3 dual-frequency ultrasound facial machine, including 3 MHz vs 10 MHz settings and common mistakes to avoid.

Quick answer

Use the FaceEvo 3 with a generous layer of conductive gel, keep the ultrasound handle moving, and match frequency to the treatment goal: 3 MHz for deeper, broader areas and 10 MHz for superficial, precision work. Treat each area for a short, consistent pass rather than lingering in one spot.

Why frequency choice changes your treatment plan

The FaceEvo 3 is a dual-frequency ultrasound facial machine, so the 3 MHz and 10 MHz settings are not interchangeable. Lower-frequency ultrasound penetrates more deeply, which suits broader facial regions and areas with more tissue. Higher-frequency ultrasound concentrates energy closer to the surface, making it the better choice for precise, superficial work along the jawline, around the eyes, or on smaller zones.

A common mistake is choosing 10 MHz because it sounds more advanced, then treating large areas with it. That can leave you working too slowly or too long in one place. Decide the frequency per zone before you start, and write it into your treatment plan so every session is consistent.

Preparation and safety checks that are easy to skip

Ultrasound needs a coupling medium. Without enough gel, the handle drags and the energy does not transfer predictably. Check the skin for breaks, active irritation, or recent cosmetic procedures before every session; if the skin is compromised, postpone the treatment rather than working around it.

The catalog does not list specific intensity levels or treatment durations for the FaceEvo 3, so do not guess them. Start with the lowest setting you can use effectively and build a written protocol from your own supervised experience.

Safe professional ultrasound facial steps

  1. 1. Clean and assess the skin: Remove makeup and cleanse the treatment area, then inspect for redness, broken skin, or irritation. Do not treat over compromised skin. If you find a compromised area, reschedule rather than treating around it.
  2. 2. Apply a thick, even layer of conductive gel: Cover the entire treatment zone so the handle glides without pulling. Reapply gel as it thins during the session. Dry patches are the most common cause of inconsistent ultrasound delivery.
  3. 3. Choose 3 MHz for broad or deeper zones: Select the 3 MHz setting when treating larger areas such as the cheeks or the full face. Keep the handle moving in slow, overlapping passes. Do not switch to 10 MHz mid-zone; finish the area at one frequency.
  4. 4. Switch to 10 MHz for precision areas: Use 10 MHz along the jawline, around the eyes, and on smaller zones where you want superficial, focused work. Reduce your pass length compared with 3 MHz. Mark your intended 10 MHz zones before starting so you do not over-treat them.
  5. 5. Keep the handle moving at all times: Use continuous, overlapping strokes rather than holding the handle still. Pause and lift the handle if you need to reposition. A stationary handle is the main safety error in ultrasound facials.
  6. 6. Remove gel and finish with a barrier product: Wipe away residual gel gently, then apply a soothing moisturizer or barrier cream. Skip actives immediately after treatment. Record the frequency and pass count you used so the next session is repeatable.

Product facts

Related Articles

Customer Service
Home
Products
Cart
Profile